Unit Usp 1020d Instruktsiia -

The will flash. Use the MEM button to change the value, then press SET to confirm. Repeat this process for Month , Day , Hour , and Minute . Preparing for Measurement

Press the MEM button. It will first show the average of the last 3 readings. Press it again to scroll through previous entries. unit usp 1020d instruktsiia

To get the most accurate results, follow these preparation steps: Sit quietly for 5 minutes before starting. The will flash

Remove batteries if the device will not be used for more than 3 months. Preparing for Measurement Press the MEM button

The cuff will automatically inflate. during this time.

Before taking your first measurement, ensure the device is configured correctly. 1. Power Supply

Sit upright in a chair with your back supported and feet flat on the floor. Cuff Placement: Place the cuff on your bare left arm. Position it about 1–2 cm (0.5 inches) above the elbow. The air tube should run down the center of your inner arm. 🩺 Taking a Measurement Press the START/STOP button.