Speed Searchв Control V 15.0.2 Access

Decide if you want it to trigger automatically after a power loss or every time a "Run" command is given. 2. Configure Current and Timing

Look for a steady LED indicator or a software status bit that confirms the drive is in "Speed Search" mode during startup.

If you are using a specific software suite (like or Alta Control ) where "v 15.0.2" refers to a firmware version, check the Cisco Bug Search Tool or the Alta Release Notes to see if "Speed Search" refers to a new UI search optimization or performance feature. Speed searchВ Control v 15.0.2

To prepare or enable the feature in a control system (such as Yaskawa or similar VFD controllers ), follow these general configuration steps: 1. Enable the Speed Search Function

Locate the primary activation parameter in your control interface. Decide if you want it to trigger automatically

Set b3-01 (Speed Search Selection) to 1 (Enabled) .

Typically set between 100% and 150% of the motor's rated current. This determines how much "effort" the drive uses to find the frequency. If you are using a specific software suite

In the context of industrial automation and , "Speed Search" (often called "Catch-on-the-Fly") is a feature that allows a drive to restart into a motor that is already spinning (e.g., after a brief power loss or while a fan is windmilling).