Once the blinking stops or the TV reboots, remove the USB drive. Important Safety Notes
This is a "General" firmware, meaning it usually supports standard remote controls. If your remote doesn't work after flashing, you may need to use the physical buttons on the TV to access the menu and adjust settings. Once the blinking stops or the TV reboots,
Ensure your LVDS cable and panel voltage (3.3V, 5V, or 12V) are correctly set via the jumper on the board before powering on, or you may damage the screen. Ensure your LVDS cable and panel voltage (3
.rar (Requires extraction to get the .bin file) Update Method: USB Interface How to Install the Firmware You should see a file named SI6M_56_E
Format a USB drive (8GB or smaller recommended) to FAT32 .
Use WinRAR or 7-Zip to extract the downloaded .rar archive. You should see a file named SI6M_56_E.bin (or similar).
Place the extracted .bin file directly into the root directory of the USB drive. Do not put it inside a folder. Flashing Process: Turn off the TV/Board power. Insert the USB drive into the TV's USB port. Plug in the power cord or turn the power on.