: Connect the power cord. While the cutter has a USB port, it uses a "USB-to-serial" chip that can be unstable. Many experts on the USCutter Forum
: You may need FTDI VCP drivers available from FTDI Chip to allow the OS to send commands via USB. 3. Software Configuration
: Place your vinyl under the pinch rollers and lock them down.
Set the output device to the correct found in your computer's Device Manager. Ensure the Baud Rate is set to 9600 . VinylMaster Setup :
model and choose "Direct USB" or "Direct COM" depending on your cable. 4. Running Your First Cut
is a 28-inch model typically requiring a stand for stability. :
If you are using the USB connection, you must install the proper drivers to create a virtual COM port.